Maintenance
74
2.
Remove the propeller nut, washer, and
spacer.
WARNING! Do not use your
hand to hold the propeller when loos-
ening the propeller nut.
[EWM01891]
F200C, FL200C, F225B, FL225B
F225C
3.
Remove the propeller, spacer (if
equipped), and thrust washer.
EMU42643
Installing propeller
WARNING
EWM00771
On counter rotation models, be sure to
use a propeller intended for counterclock-
wise rotation. These propellers are identi-
fied with the letter “L” after the size
indication on the propeller. Otherwise the
boat could move in the opposite direction
from that expected.
NOTICE
ECM00502
Make sure to use a new cotter pin and
bend the ends over securely. Otherwise,
the propeller could come off during oper-
ation and be lost.
1.
Apply Yamaha marine grease or a corro-
sion resistant grease to the propeller
shaft.
2.
Install the thrust washer, spacer (if
equipped), and propeller on the propeller
shaft.
NOTICE:
Make sure to install the
thrust washer before installing the
propeller. Otherwise, the lower case
and propeller boss could be damaged.
[ECM01882]
3.
Install the spacer, washer, and propeller
nut. Tighten the propeller nut to the
specified torque.
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Spacer
7. Thrust washer
4 3
2
1
5
6
ZMU07269
ZMU07547
4 3
2
1
5
6
7
U6P27AE0.book Page 74 Friday, December 6, 2013 6:17 PM
