Maintenance
73
Change the oil more often when operating
the engine under adverse conditions such
as extended trolling.
EMU29115
Inspecting wiring and connectors
Inspect that each connector is engaged se-
curely.
Inspect that each ground lead is properly
secured.
EMU32113
Checking propeller
WARNING
EWM01882
You could be seriously injured if the en-
gine accidentally starts when you are near
the propeller. Before inspecting, remov-
ing, or installing the propeller, place the
shift control in neutral, turn the main
switch to “
” (off) and remove the key,
and remove the clip from the engine shut-
off switch. Turn off the battery cut-off
switch if your boat has one.
Do not use your hand to hold the propeller
when loosening or tightening the propeller
nut. Put a wood block between the anti-cavi-
tation plate and the propeller to prevent the
propeller from turning.
Checkpoints
Check each of the propeller blades for ero-
sion from cavitation or ventilation, or other
damage.
Check the propeller shaft for damage.
Check the splines for wear or damage.
Check for fish line tangled around the pro-
peller shaft.
Check the propeller shaft oil seal for dam-
age.
EMU42632
Removing propeller
1.
Straighten the cotter pin and pull it out
using a pair of pliers.
U6P27AE0.book Page 73 Friday, December 6, 2013 6:17 PM
