Yamaha Fazer FZ8-SA, Service Manual

Page: 515 / 610

IMMOBILIZER SYSTEM
8-120
EAS27691
PART REPLACEMENT AND KEY CODE REGISTRATION REQUIREMENTS
In the course of use, you may encounter the following cases where replacement of parts and regis-
tration of code re-registering/standard keys are required.
TIP
Each standard key is registered during production, therefore re-registering at purchase is not neces-
sary.
* Accessory locks mean the seat lock and fuel tank cap.
Code re-registering key registration:
When the immobilizer unit or ECU is replaced, the code re-registering key must be registered to the
unit.
To register a code re-registering key:
1. Turn the main switch to “ON” with the code re-registering key.
TIP
Check that the immobilizer system indicator light comes on for one second, then goes off. When the
immobilizer system indicator light goes off, the code re-registering key has been registered.
2. Check that the engine can be started.
3. Register the standard key, following the instructions in the section below.
Parts to be replaced
Key registration
requirement
Main switch/
immobilizer unit
Standard
key
ECU
Acces-
sory lock*
and key
Main
switch Immobi-
lizer unit
Standard key is lost
√
New standard key
All keys have been
lost (including code
re-registering key)
√ √ √ √
Code re-registering
key and standard
keys
ECU is defective
√
Code re-registering
key and standard
keys
Immobilizer unit is
defective
√
Code re-registering
key and standard
keys
Main switch is defec-
tive
√ √ √ √
Code re-registering
key and standard
keys
Accessory lock* is
defective
√
Not required