Operation
33
an emergency reserve. With the boat level on
a trailer or in the water, check the fuel level.
For fuel filling instructions, see page 36.
EMU39840
Removing top cowling
For the following checks, remove the top
cowling from the bottom cowling.
To remove the top cowling, pull the cowling
lock lever up and lift up the top cowling.
EMU36442
Fuel system
WARNING
EWM00060
Gasoline and its vapors are highly flam-
mable and explosive. Keep away from
sparks, cigarettes, flames, or other sourc-
es of ignition.
WARNING
EWM00910
Leaking fuel can result in fire or explosion.
●
Check for fuel leakage regularly.
●
If any fuel leakage is found, the fuel sys-
tem must be repaired by a qualified me-
chanic. Improper repairs can make the
outboard unsafe to operate.
EMU36451
Check for fuel leaks
●
Check for fuel leaks or gasoline fumes in
the boat.
●
Check for fuel leakage from the fuel system.
●
Check the fuel tank and fuel lines for
cracks, swellings, or other damages.
EMU36902
Controls
Tiller handle models:
●
Move the tiller handle fully to the left and
right to make sure operation is smooth.
●
Turn the throttle grip from the fully closed to
the fully open position. Make sure that it
turns smoothly and that it completely re-
turns to the fully closed position.
●
Look for loose or damaged connections of
the throttle and shift cables.
Remote control models:
●
Turn the steering wheel full-right and full-
left. Make sure operation is smooth and un-
restricted throughout the whole range with
no binding or excessive free play.
●
Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
●
Look for loose or damaged connections of
the throttle and shift cables.
EMU36483
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
1. Cowling lock lever
1
ZMU07824
1. Clip
2. Cord
ZMU06873
1
2
U6DR70E0.book Page 33 Thursday, December 6, 2012 9:14 AM