Operation
56
2.
After stopping the engine, disconnect the
fuel line if there is a fuel joint on the out-
board motor.
3.
Tighten the air vent screw on the fuel tank
cap (if equipped).
4.
Remove the key if the boat will be left un-
attended.
5.
When you leave your boat, set the
Yamaha Security System to the lock
mode by pressing the lock button of the
remote control transmitter. Short beep
will sound once when locking the security
system. The lock mode is selected only
when the main switch is in the “
” (off)
position. For further information, see
page 19.
WARNING! Do not set the
Yamaha Security System in the lock
mode when you stop the engine at off-
shore.
[EWM02150]
TIP:
The engine can also be stopped by pulling the
cord and removing the clip from the engine
shut-off switch, then turning the main switch
to “
” (off).
EMU27862
Trimming outboard motor
WARNING
EWM00740
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make steer-
ing the boat more difficult. This increases
the possibility of an accident. If the boat
begins to feel unstable or is hard to steer,
slow down and/or readjust the trim angle.
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim an-
gle depends upon the combination of boat,
engine, and propeller. Correct trim is also af-
fected by variables such as the load in the
boat, sea conditions, and running speed.
ZMU02041
1. Trim operating angle
1
ZMU04258
U6D779E0.book Page 56 Tuesday, November 15, 2011 2:33 PM
