Operation
45
EMU36903
Controls
Tiller handle models:
Move the tiller handle fully to the left and
right to make sure operation is smooth.
Turn the throttle grip from the fully closed
to the fully open position. Make sure that it
turns smoothly and that it completely re-
turns to the fully closed position.
Look for loose or damaged connections of
the throttle and shift cables.
Remote control models:
Turn the steering wheel full-right and full-
left. Make sure operation is smooth and
unrestricted throughout the whole range
with no binding or excessive free play.
Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
Look for loose or damaged connections of
the throttle and shift cables.
EMU36484
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
EMU40994
Engine oil
(1) Place the outboard motor in a vertical
position (not tilted).
NOTICE:
If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01862]
(2) Remove the oil dipstick and wipe it
clean.
ZMU07079
1. Clip
2. Engine shut-off cord (lanyard)
ZMU07105
1
2
6C1-9-7J-1E0.book 45 ページ ２０１９年１０月３０日 水曜日 午後２時５６分
