Yamaha F30B 2018, Service Manual

Page: 326 / 348

10-21
General periodic maintenance
b. Remove the reservoir cap “1” and O-ring
“2”, and then check the fluid level in the
reservoir.
Before removing the reservoir cap, make
sure that the trim and tilt ram is fully ex-
tended. Otherwise, fluid could be expelled
forcefully from the PTT unit due to internal
pressure.
TIP:
If the fluid is at the proper level, a small amount
of fluid should flow out of the filler hole when
the reservoir cap is removed.
c. If the fluid is below the proper level, add
the recommended fluid.
d. Install a new O-ring and the reservoir cap,
and then tighten the reservoir cap to the
specified torque.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
Checking the cowling lock lever
1. Check:
• Top cowling fitting
Looseness/ratting

Adjust.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Check the fitting by pushing the top cowl-
ing.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
2. Adjust:
• Top cowling fitting
Looseness/rattling

Replace the cowling
seal.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen the nuts “1”.
b. Move the hook “2” up or down slightly to
adjust its position.
TIP:
• To loosen the fitting, move the hook in direc-
tion “a”.
• To tighten the fitting, move the hook in direc-
tion “b”.
c. Tighten the nut.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
Reservoir cap
7 N·m (0.7 kgf·m, 5.2 lb·ft)
1
2
T
R
.
.
1
2
a
b