Yamaha F30A, Service Manual

Page: 204 / 285

BRKT
Bracket unit
7-23
67C3K11
Installing the steering arm
1. Install the washer
1
, bushing 1
2
, a
new O-ring
3
, and bushing 2
4
onto the
steering arm
5
.
2. Place the swivel bracket
6
in an upright
position, and then install the steering arm
onto the bracket.
3. Install bushing 2
7
, a new O-ring
8
, and
the plate
9
onto the steering arm.
4. Install the steering yoke
0
onto the
steering arm, making sure that they are
both facing in the same direction (
a
and
b
are aligned).
È
S-transom model
NOTE:
Hold the steering arm, and then strike the
steering yoke
0
with a copper hammer to
install it.
5. Apply grease to the grease nipple
A
on
the swivel bracket until it comes out from
the upper bushing
c
.
NOTE:
To assemble the clamp brackets, see “Install-
ing the clamp bracket” (7-29).
Installing the upper case
1. Install the lower mount assemblies
1
to
the upper case assembly
2
.
2. Install the upper case assembly
2
to the
steering arm, install the ground lead ter-
minal
3
, and then tighten the nuts
4
to
the specified torque. Also, tighten the
nuts
5
.
3. Install the lower mount housings
6
.
4. Install the ground lead terminals
7
and
8
.
5. Install the lower mount cover
9
. (L-tran-
som model)
S67C7029
A A
A A
A A
2
1
5
7
3
8
4
9
6
S67C7121
A A
0 È
0
a
b
S67C7030
A A
c
A