9-57
BRKT
Bracket unit
2.
Install the trim ram assemblies, and then
tighten the trim cylinder end screws
a
to
the specified torque.
Installing the tilt ram
When assembling the PTT unit, do not use
a rag. Otherwise, dust and particles could
get on the PTT unit components, causing
poor performance.
1.
Place the tilt cylinder end screw
a
at the
bottom of the tilt ram assembly.
2.
Fill the tilt cylinder with the recommended
fluid up to the proper level
a
.
3.
Add a small amount of the recommended
fluid through the PTT body hole
b
.
4.
Install the tilt piston assembly into the tilt
cylinder, and then tighten the tilt cylinder
end screw
a
to the specified torque.
Cylinder-end screw wrench
b
:
90890-06568
Trim cylinder end screw
a
:
160 N·m (16.0 kgf·m, 118.0 ft·lb)
a
a
b
a
Cylinder-end screw wrench
b
:
90890-06568
Tilt cylinder end screw
a
:
90 N·m (9.0 kgf·m, 66.4 ft·lb)
a
a
b
a
a
b
Summary of Contents for F225F
