Trouble Recovery
93
4.
Remove the filter cup from the filter
housing, and then remove the O-ring
from the filter cup.
NOTICE:
Be careful
not to twist the water detection switch
lead when unscrewing the filter cup.
[ECM01961]
5.
Drain the water in the filter cup by soak-
ing it up with a rag.
6.
Put the O-ring on the filter cup in its orig-
inal position, and then install the filter cup
onto the filter housing.
NOTICE:
Be
careful not to twist the water detec-
tion switch lead when screwing the fil-
ter cup onto the filter housing.
[ECM01971]
7.
Connect the water detection switch cou-
pler securely until a click is heard.
8.
Install the top cowling.
9.
Turn the main switch to the “
” (on) po-
sition and check that the water separa-
tor-alert indicator remains off and the
buzzer does not sound. If the water sep-
arator-alert indicator blinks or the buzzer
sounds, have your Yamaha dealer check
the outboard motor.
NOTICE:
Although
the buzzer will stop when the engine is
started and the control lever is moved
to the forward or reverse position, do
not use the outboard motor. Other-
wise, serious engine damage could
occur.
[ECM02481]
EMU33502
Treatment of submerged motor
If the outboard motor is submerged, immedi-
ately take it to a Yamaha dealer. Otherwise
some corrosion may begin almost immedi-
ately.
NOTICE:
Do not attempt to run the
outboard motor until it has been com-
pletely inspected.
[ECM00402]
1. Water detection switch coupler
1. Filter housing
2. O-ring
3. Filter cup
4. Water detection switch lead
1
ZMU07789
1
2
3
4
ZMU07790
1. O-ring
2. Filter cup
3. Water detection switch lead
2
3
1
ZMU07791
U6DV72E0.book Page 93 Friday, December 19, 2014 3:38 PM
