Yamaha F200B, Service Manual

Page: 80 / 579

3-11
RIG
GING
Rigging information
16. Fully screw in the throttle cable joint
B
to
the throttle cable
A
.
17. Pull the inner cable so that there is no
free play (backlash).
18. Check that the accelerator lever
n
con-
tacts the stopper
p
.
19. Adjust the throttle cable joint
B
, and then
connect the throttle cable joint
B
to the
pin
r
of the accelerator lever
n
.
WARNING! The throttle cable joint
must be screwed in 8.0 mm (0.31 in) or
more.
20. Install the clip C , and then tighten the
throttle cable locknut D to the specified
torque.
21. Check the shift cable and throttle cable
for proper operation.
Installing the wiring harness
1. Remove the 10-pin coupler
a
from the
holder
b
on the bracket.
2. Route the extension wiring harness
through the bottom cowling.
3. Connect the 10-pin coupler
c
, and then
fasten it using the holders
b
and
d
on
the bracket.
Installing the isolator lead (optional)
1. Remove the cap
1
.
2. Route the isolator lead
2
through the
bottom cowling.
Dimension
s
: 8.0 mm (0.31 in) or more
A
B
B
s
p
n
r
B
D C
Throttle cable locknut
D
:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
b
a
d
b
c
1