Yamaha F200B, Service Manual

Page: 270 / 579

7-11
POWR
Power unit
28. Remove the power unit mounting bolts
V
and
W
, and then remove the power unit
U
, gasket
X
, and dowels
Y
.
Installing the power unit
Before installing the power unit, make sure to
install the shift rod and shift bracket onto the
bottom cowling. See “Shift rod and shift
bracket” (9-1).
Do not reuse a gasket or O-ring, always
replace it with a new one.
1. Retract the cowling lock levers (PORT
and STBD).
NOTICE: Make sure that
the cowling lock levers are retracted
and the engine stoppers are installed
before installing the power unit. Oth-
erwise, the fuel rails could be dam-
aged.
2. Clean the power unit mating surface, and
then the install the dowels
1
and a new
gasket
2
.
3. Hook a lifting harness to the engine
hangers
3
, and then suspend the power
unit
4
.
4. Install the power unit
4
, and then tighten
the power unit mounting bolts
5
and
6
to the specified torque.
W
W
V
V
V
Y
T
U
T
W
V
V
V
Y
X
Power unit mounting bolt
5
and
6
:
42 N·m (4.2 kgf·m, 31.0 ft·lb)
T POR
STBD
5
6
6
5
5
1
2
4
5
5
5
6
3
3
3