Yamaha F2.5C, Service Manual

Page: 42 / 184

CHK
ADJ
Periodic checks and adjustments
3-11
6D55F11
4. Check that the
a
is specified timing on
the flywheel magnet.
Bracket
3
Checking the tilt operation
1. Fully tilt the outboard motor up and down
a few times and check the entire tilt
range for smooth operation. Check the tilt
mechanism if necessary.
2. Fully tilt the outboard motor up, then sup-
port it with the tilt stop lever
1
to check
the lock mechanism of the lever.
Lower unit
3
Checking the gear oil level
1. Fully tilt the outboard motor down.
2. Remove the check screw
1
, and then
check the gear oil level in the lower case.
NOTE:
• If the oil is at the correct level, the oil should
overflow out of the check hole when the
check screw is removed.
• If necessary, add sufficient gear oil of the
recommended type until it overflows out of
the check hole.
3. Install the check screw.
Ignition timing at engine idle speed:
BTDC 8.5°
S6D53360
S60V3320
1