Yamaha EMX 5000-12, Owner'S Manual

Page: 22 / 38

20
Installation/Connections
EMX5000-20/EMX5000-12—Owner’s Manual
• Two channel parallel connections
If you connect two speakers in parallel to the SPEAKERS A and SPEAKERS B jacks, use speakers with an
impedance in the range of 8–16 ohms. A maximum output of 500W + 500W will be obtained when 8-ohm
speakers are used.
■
When the power amp select switch is set to MONO BRIDGE:
• Bridge connection
Connect only one 8–16 ohm speaker to the A1 jack. The speaker will output the combined monaural signal of
the STEREO bus. A maximum output of 1000 W will be obtained when an 8-ohm speaker is used.
If you are inputting a signal from the P.AMP IN jack, input it to P.AMP IN jack A.
Caution:
When using a bridge connection,
do not connect a speaker to the B or A 2 jack.
Two-channel connection Two-channel parallel connection
Main
Speaker
Main/Monitor
Speaker
Main
Speaker
Main/Monitor
Speaker
or
or
* Use either the 1 (Speakon) jacks
or 2 (phone) jacks of and .
* Use either the 1 (Speakon) jacks
or 2 (phone) jacks of and .
4
Ω
–8
Ω
4
Ω
–8
Ω
8
Ω
–16
Ω
8
Ω
–16
Ω
8
Ω
–16
Ω
8
Ω
–16
Ω
Main Speaker
Bridge connection
No
connection
* Use the 1+(+) and 2+(–) pins of the 1
jack.
8
Ω
–16
Ω
No
connection