E-9
English
CONNECTIONS
Connecting speakers
(See figure
6
on page
6
6
.)
Connect the front speakers to the FRONT SPEAKERS
terminals, the center speaker to the CENTER SPEAKERS
terminals and the rear speakers to the REAR SPEAKERS
terminals.
Note
Use speakers with the specified impedance shown on the
rear of this unit.
How to Connect:
Connect the SPEAKERS terminals to your speakers with wire
of the proper gauge, cut as short as possible. If the
connections are faulty, no sound will be heard from the
speakers. Make sure that the polarity of the speaker wires is
correct, that is the + and – markings are observed. If these
wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other as
this could damage the amplifier and/or speakers.
Red: positive (+)
Black: negative (–)
➀
Press up the tab.
➁
Insert the bare wire.
[Remove approx.
5mm (1/4”) insulation
from the speaker
wires.]
➂
Press down the tab
and secure the wire.
➀
➁
➂
Never plug the AC supply lead of this system into the AC outlet until all connections are
completed.
Note on connecting a subwoofer (separate
purchase)
You may wish to add a subwoofer to reinforce the bass
frequencies.
Connect the SUBWOOFER OUT terminal on the rear of
this unit to the INPUT terminal of the subwoofer
amplifier, and connect the speaker terminals of the
subwoofer amplifier to the subwoofer.
With some subwoofers, including the Yamaha Active
Servo Processing Subwoofer System, the amplifier and
subwoofer are in the same unit.
* The SUBWOOFER OUT terminal is for output to a
monaural amplifier driving a subwoofer. Only frequencies
below 200 Hz from the front and center channels are
output.
Connecting external components
(See figure
7
on page
7
7
.)
This unit can be connected with external audio and video
components. Make connections between this unit and other
components using RCA pin plug connector cables correctly, that
is to say L (left) to L and R (right) to R. Also, refer to the owner’s
manual for each component to be connected to this unit.
Connecting the AC supply lead
(See figure
8
on page
8
8
.)
•
After completing all connections, plug the AC supply lead
into a convenient AC outlet.
•
Unplug the AC supply lead from the AC outlet if the unit is
not to be used for a long period of time.
TURNING THE POWER ON/OFF TO THIS UNIT
(See figure
9
on page
8
8
.)
If the AC supply lead is connected to the AC outlet, this unit
can be turned on and off (standby mode) by pressing the
POWER switch on the front panel of this unit or the POWER
switch on the remote control transmitter.
Automatic power-off function
The power of this unit will be automatically turned off if there
is no operation on the control parts of this unit, no illumination
on the graphic equalizer level indicators and no playback of
CD for about 30 minutes.
*
This function is not available unless time setting is made
on the built-in clock.
Standby mode
While the power is on, pressing the POWER switch (or the
POWER switch on the remote control transmitter) switches
this unit to the standby mode. (In this mode, the display
shows only the time.) In this mode, main voltage is still
present inside the system. If you want to switch off this unit
completely, disconnect the AC power plug from the AC
outlet.
