DVD-C961
7
75
(2-15/16")
425 (16-3/4")
435 (17-1/8")
HDMI, the HDMI logo and High
Definition Multimedia Interface are
trademarks or registered trade-
marks of HDMI Licensing LLC.
• DIMENSIONS
Unit: mm (inch)
This product incorporates copyright protection technology
that is protected by method claims of certain U.S. patents
and other intellectual property rights owned by Macrovision
Corporation and other rights owners. Use of this copyright
protection technology must be authorized by Macrovision
Corporation, and is intended for home and other limited
viewing uses only unless otherwise authorized by
Macrovision Corporation. Reverse engineering or disassem-
bly is prohibited.
DivX, DivX Ultra Certified, and as-
sociated logos are trademarks of
DivX, Inc. and are used under li-
cense.
■
INTERNAL VIEW
8
9
0
7
1
2
3
4
5
6
1
2
3
4
5
6
7
8
9
0
POWER SUPPLY UNIT
RS232C P.C.B.
DVD 5-DISC CHANGER MODULE
FRONT (4) P.C.B.
HDMI P.C.B.
AV P.C.B.
MONO P.C.B.
FRONT (2) P.C.B.
FRONT (1) P.C.B.
FRONT (3) P.C.B.
Power supply unit
Front side
RS232C P.C.B.
OK
NG
Top view
Switch (Ref. No. 1107)
Potentiometer (Ref. No. VR1)
■
REPAIR NOTES
1. DVD 5-disc changer module
•
When installing a new traverse unit, remove the solder from the shorted point of P.C.B. using an electrostatic
shielding soldering iron. (Fig. 1)
2. Power supply unit
•
The power supply unit has to be replaced in case of failure.
•
Never touch the potentiometer (Ref. No. VR1) installed to the power supply unit. (Fig. 2)
3. P.C.B. assembly
•
When a failure has occurred in the P.C.B. assembly, replace each P.C.B..
•
Never touch the switch (Ref. No. 1107) installed to the RS232C P.C.B.. (Fig. 2)
Fig. 1
Fig. 2
Traverse unit
Solder
