Assembly Guide
16
Setup
DTX402K DTX432K DTX452K Owner’s Manual
Attaching the hi-hat pad
Adjusting the position of the hi-hat stopper
1.
Loosen the
key bolt on the stopper, which is located at the top of the hi-hat holder.
2.
Adjust the position of the stopper until it is straight in the back (as shown in the illustration) from your playing position.
3.
Tighten the
key bolt to secure the stopper.
Assembling the hi-hat pad
1.
Remove the wing nut, the washer, and the upper felt pad from
the hi-hat holder. (Do not remove the lower felt pad.)
2.
Place the hi-hat pad, which does
NOT
have a sticker labeled
“CRASH,” on the hi-hat holder with the stopper also passing
through the hole provided.
3.
Replace the felt pad removed in
Step 1
above the hi-hat pad.
4.
Replace the washer removed in
Step 1
above the felt pad.
5.
Tighten the wing nut to secure the hi-hat pad in place.
Attaching the drum module
1.
Loosen the
key bolt on the back left of the rack and turn the joint around before sliding the sliding the drum module (in
the next step).
2.
Loosen the
s
key bolt and slide the drum module fully back into the joint in
Step 1
.
3.
Tighten the
and
s
key bolts to secure the drum module in place.
Step 7
Playing position
Stopper
Wing nut
Felt pad
Hi-hat pad
Hi-hat holder
Stopper
Washer
Felt pad
Step 8
