Advanced Techniques
DTX502 O
w
ner’s Man
u
al
Setting Parameters using Menu Mode
75
System8
Auto Power-Off
q
AutoPwrOff
Use this parameter to set the time until the Auto Power-Off
function activates (page 13) or to disable (“off”) this function.
System9
Restore
Using the Restore function as described below, you can return all
User data (i.e., kits, click sets, trigger setups, and songs) to the
settings they had when you last turned on the drum module.
1.
Press the [SAVE/ENTER] button on the Restore page.
You will be asked to confirm that you wish to proceed.
To cancel the Restore process, press the [
] button.
2.
Press the [SAVE/ENTER] button to reset the parameters.
3.
When the parameters have been successfully reset, the mes-
sage “Completed.” will be displayed.
4.
The drum module will automatically restart.
System10
Factory Set
Using the procedure described below, you can return all User data
(i.e., kits, click sets, trigger setups, and songs) to the default set-
tings.
1.
Press the [SAVE/ENTER] button on the Factory Set page.
You will be asked to confirm that you wish to proceed.
To cancel the process without restoring default settings,
press the [
] button.
2.
Press the [SAVE/ENTER] button to reset the parameters.
3.
When the parameters have been successfully reset, the mes-
sage “Completed.” will be displayed.
4.
When the Factory Set has been restored, the drum module
will automatically restart and the Initial Setup page will be
displayed (page 13).
Settings
off, 5, 10, 15, 30, 60, and 120 (min)
NOTE
• Settings for the A
u
to Po
w
er-Off f
u
nction do not represent exact
times and there may
b
e some
v
ariation.
• The dr
u
m mod
u
le a
u
tomatically stores its system settings
b
efore t
u
rning off a
u
tomatically.
CAUTION
When you reset parameters using the Restore function, any
changes you have made to them since last turning on the
drum module will be lost. Before proceeding, therefore, you
should ensure that these parameters contain no irreplace-
able settings.
>Sys
t
em8
”
Au
t
oPwrOff=30 ‚
q
>Sys
t
em9
”
Res
t
ore ‚
>Sys
t
em9 Res
t
ore
Are you sure?
CAUTION
When you reset parameters as described below, any
changes you have made to them will be lost. Before proceed-
ing, therefore, you should ensure that they contain no irre-
placeable settings.
NOTE
Yo
u
can also restore the Factory Set
b
y t
u
rning on the dr
u
m
mod
u
le
w
ith
b
oth the [
<
] and [
>
]
bu
ttons held do
w
n (page 14)
>Sys
t
em
:
” Fac
t
ory Se
t
>Sys
t
em
:
Fac
t
Se
t
Are you sure?
>Sys
t
em
:
Fac
t
Se
t
Execu
t
ing...
