Yamaha DSP-Z11 Page 28 Owner'S Manual Download

Page: 28 / 150

Connections

■

Audio jacks

This unit has three types of audio jacks. Connection depends on the
availability of audio jacks on your other components.

AUDIO jacks

For conventional analog audio signals transmitted via left and right
analog audio cables. Connect red plugs to the right jacks and white
plugs to the left jacks.

DIGITAL COAXIAL jacks

For digital audio signals transmitted via coaxial digital audio cables.

DIGITAL OPTICAL jacks

For digital audio signals transmitted via optical digital audio cables.

You can use the digital jacks to input PCM, Dolby Digital and DTS
bitstreams. When you connect components to both the COAXIAL and
OPTICAL jacks, priority is given to the signals input at the COAXIAL jack.
All digital input jacks are compatible with 96-kHz sampling digital signals.

■

Video jacks

This unit has three types of video jacks. Connect the video input
jacks on this unit to the video output jacks of the input source
components to switch the audio and video sources simultaneously.
Connection depends on the availability of input jacks on your video
monitor.

VIDEO jacks

For conventional composite video signals transmitted via composite
video cables.

S VIDEO jacks

For S-video signals, separated into the luminance (Y) and
chrominance (C) video signals transmitted on separate wires of S-
video cables.

COMPONENT VIDEO jacks

For component video signals, separated into the luminance (Y) and
chrominance (P

, P

) video signals transmitted on separate wires of

component video cables.

This unit is equipped with the video conversion function. See pages 29 and
89 for details.

■

HDMI jack and cable plug

This unit has five HDMI input jacks and two HDMI output jacks for
digital audio and video signal input/output.

• We recommend that you use a commercially available HDMI cable shorter

than 5 meters (16 feet) with the HDMI logo printed on it.

• Use a conversion cable (HDMI jack

↔

DVI-D jack) to connect this unit to

other DVI components.

• You can check the potential problem about the HDMI connection (see

page 95).

• See page 139 for the information on the input signal capability of this unit

for the HDMI connection.

• When you set “Standby Through” in “Manual Setup” to “On”, this unit

allows the HDMI signals input at an HDMI IN jack to pass through this
unit and output at an HDMI OUT jack (see page 94).

• Do not disconnect or connect the cable or turn off the power of the HDMI

components connected to the HDMI OUT jacks on this unit while data is
being transferred. Doing so may disrupt playback or cause noise.

• The HDMI OUT jacks output the audio signals input at the HDMI input

jacks only when “Support Audio” is set to “Other” (see page 94).

• If you turn off the power of the video monitor connected to the HDMI

OUT jacks via a DVI connection, this unit may fail to establish the
connection to the component.

• The analog video signals input at the composite video, S-video and

component video jacks can be digitally up-converted to be output at the
HDMI OUT jacks. Set “Conversion” to “On” in “Manual Setup” (see
page 89) to activate this feature.

• This unit is equipped with two HDMI OUT jacks, however cannot output

the video signals to the both HDMI OUT jacks simultaneously. You can
select the active HDMI OUT jack. See page 50 for details.

Information on jacks and cable plugs

Note

COAXIAL

DIGITAL

AUDIO

OPTICAL

DIGITAL

Left and right analog

audio cable plugs

Optical digital