1
Yamaha DM2000 Update V1.1
This document explains the new and revised func-
tions for DM2000 Update 1.1.
Scene Memory & Input/Output Patch
Linking
Input Patch and Output Patch library memories can
be linked to Scene memories so that when a Scene is
recalled, the input and output patches are recalled as
well.
The PATCH LINK INPUT and OUTPUT parame-
ters can be found on the Scene Memory page shown
below, which is located by pressing the SCENE
MEMORY [DISPLAY] button.
Use the cursor buttons to select the PATCH LINK
INPUT and OUTPUT parameters, use the Parame-
ter wheel to select Input Patch and Output Patch
library memories, and press the [ENTER] button to
set. A dash (–) means that no patch memory is
selected.
When you store a Scene, the last recalled or stored
Input Patch and Output Patch library memories are
automatically linked to that Scene.
If the specified Input or Output Patch library mem-
ory contains no data, only the Scene is recalled, the
input and output patching will remain the same.
Bass Management for 3-1 & ST
Monitor Matrixes
Bass Management can now be used with the 3-1 and
Stereo Out monitor matrixes. Previously, Bass Man-
agement could be used only with the 5.1 monitor
matrix. The Bass Management function can be
found on the Surround Monitor Setup page, which
can be located by using the MONITOR [DISPLAY]
button when either the 3-1 or 5.1 Surround mode is
selected.
The following screen shots show the Bass Manage-
ment configurations for the 5.1, 3-1, and Stereo
monitor matrixes, with Bass Management turned on
and off.
In addition, the Monitor Matrix configurations have
changed as follows. (The 5.1 to 5.1 matrix is
unchanged.)
Note: When using the 3-1 monitor matrix, even with
film sources, use Bass Management presets 1 and 2
(presets 3 and 4 may not provide correct monitoring).
5.1 ON
3-1 ON
ST ON
5.1 OFF
3-1 OFF
ST OFF
3-1 to 3-1
3-1 to ST
5.1 to 5.1
5.1 to 3-1
5.1 to ST
E
