Yamaha DM 1000, Owner'S Manual

Page: 150 / 388

150
Chapter 12—Grouping Channels & Linking Parameters
DM1000 Version 2—Owner’s Manual
7 To use a mute group, press one of the [ON] buttons for the grouped channels.
All channels in the group switch their on/off status.
Using Fader Group Master
The DM1000 features a Fader Group Master function that enables you to control the level of
all channels using the Group Master level while maintaining the relative balance between
channels, much like a VCA group on an analog mixing console. While this function is enabled,
channel fader operation does not affect channel levels in the corresponding Fader group.
1 After you perform Step 5 in “Using Fader Groups and Mute Groups” on
page 148, use the cursor buttons to select the INPUT FADER MASTER check
box or the OUTPUT FADER MASTER check box, then press [ENTER] to turn
on the Fader Group Master function.
2 When the Fader Master check box is checked, you can set channel levels of
the Fader groups in the Master column.
When the Master column is selected, repeatedly pressing the [ENTER] button turns the
Fader group on and off.
You can also make these settings in the In Master page or Out Master page, as shown below.
3 Press the DISPLAY ACCESS [GROUP] button repeatedly until the Group | In
Master or Group | Out Master page appears.
Note:
• While a mute group is enabled, you cannot turn a subset of the grouped channels on or off.
• If you wish to turn a subset of the grouped channels on or off, first turn off the Enable button,
or remove the channels you wish to turn on or off from the group.