PERIODIC MAINTENANCE AND ADJUSTMENT
6-27
6
EAUU1500
Replacing a tail/brake light
bulb or a rear turn signal light
bulb
If a tail/brake light bulb or a rear turn
signal light bulb burns out, replace it as
follows.
Tail/brake light bulb
1. Remove panel C. (See page 6-7.)
2. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
3. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
4. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
NOTICE
ECAU0090
If a taillight bulb of different wattage
than recommended is used, it may
cause the battery to discharge or af-
fect the taillight lighting.
5. Install the socket (together with the
bulb) by turning it clockwise.
6. Install the panel.
Rear turn signal light bulb
1. Remove panel C. (See page 6-7.)
2. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
NOTICE
ECAU0080
If a turn signal light bulb of different
wattage than recommended is used,
the turn signal light flashing may be
affected.
5. Install the socket (together with the
bulb) by turning it clockwise.
6. Install the panel.
1. Tail/brake light bulb socket
1
ZAUU0
8
19
1. Turn signal light bulb socket
1
ZAUU0
8
20
U2EPE0E0.book Page 27 Thursday, January 2, 2014 11:19 AM
