Checking the operation of an output unit
39
Connect the monitor system
In order to check the operation of an analog output unit, you will need to connect a monitor system such as a set of pow-
ered speakers or a power amp + speakers to a DA card (LMY4-DA) installed in the AO8 analog output unit.
If you are checking the output channels of a DIO8
digital input/output unit, connect the output con-
nector of the digital I/O card (MY8-AT, MY8-TD,
MY8-AE) to the digital input connector of a DAT
recorder or digital MTR (multi-track recorder) of
the same format as that card. In this case, it will not
be possible to directly monitor the signal via the
monitor system, so you will need to arrange things
so that the signal can be monitored via the head-
phone jack or analog output jacks of the recorder.
1
2
3
4
5
6
7
OUTPUT UNIT NO.
INPUT SELECTOR
A
B
POWER
ON/ OFF
8
ANALOG OUTPUT BOX
L
R
ANALOG OUT
DA CARD
MODEL LMY4-DA
SIGNAL
SIGNAL
SIGNAL
SIGNAL
CH4
CH3
CH2
CH1
D
A-Platine (LMY4-D
A)
Monitor system
AO8 analog output unit
Summary of Contents for CS1D
