Yamaha CS-R10, Systems Setup Manual

Page: 23 / 56

RIVAGE PM10 System Setup Guide
23
Channel Strip section (Bay L, Bay R, Bay C)
1
Screen encoder (Bay L and C only)
Controls the knob currently selected on the touch
screen. The knob function varies depending on the
screen currently displayed.
2
Channel strip encoder
Adjusts the gain, pan, and the other parameters of the
channel. You can assign five parameter functions
(selected from the following list) to this encoder, and
use the [UP]/[DOWN] keys to select the function.
• PAN/BALANCE
• ANALOG GAIN
• DIGITAL GAIN
• SELECTED SEND
• MIX1 SEND - MIX72 SEND
• MATRIX1 SEND - MATRIX36 SEND
• HPF FREQUENCY
• LPF FREQUENCY
• DYNAMICS1 THRESHOLD
• DYNAMICS2 THRESHOLD
• DELAY
• SILK TEXTURE
3
[Fn] key
Executes the function as assigned by the user. You
can assign one of the following functions:
• INPUT A/B
• ISOLATE
• ALTERNATE CUE
• ENCODER PARAM
• GC ON/OFF
4
[SEL] key
Enables you to select the channel that will be
controlled in the Channel Strip section or on the
display. When the channel is selected, the key LED
will light.
5 Meter LEDs
Indicate the channel level.
6 Dynamics LEDs
Indicate the status of Dynamics 1 and 2.
7
[ON] key
Switches the channel on or off. If the channel is on,
the key LED will light. In SENDS ON FADER mode,
this key works as an on/off switch for signals sent
from each channel to the currently-selected MIX/
MATRIX bus.
8 Channel name display
Indicates the channel name, fader value, etc.
9 Channel color indicator
Indicates the channel color. You can select the
channel color from 11 options including OFF.
1
2
3
4
5
7
8
9
)
!
@
#
$
6