Troubleshooting
42
En
Messages on the front panel display
Message
Cause
Solution
Unknown
There is a problem with the signal path from your iPod to this unit.
Reconnect the iPod.
The iPod/USB device being connected is not supported by the unit.
Use a supported iPod/USB device (
The iPod software is out of date.
Download the latest iTunes software from Apple’s website to update the iPod software
version.
Timer not work
The unit is in the eco standby mode.
Set [Power Saving] to [Normal] with the option setting (
Overcurrent
The connected iPod/USB device is not supported by the unit.
Disconnect the iPod/USB device, turn off the unit, and turn it on again. If this does not
solve the problem for the USB device, it is not playable on the unit.
iPod/USB device is not connected properly.
Unplugged
iPod/USB device is not connected firmly.
Disconnect the iPod/USB device and reconnect it (
P.15).
No Disc
The disc set in the unit may not be supported by the unit.
Use a disc supported by the unit (
The disc may be dirty, or foreign objects may be attached to it.
Remove the disc and then wipe the disc clean.
Disc is set upside-down.
Set the disc with the labeled side facing up.
No Songs
The disc does not contain playable files.
Set a disc with playable files (
P.43).
Initializing
The unit is starting up.
Wait until the message disappears. If the message stays more than 3 minutes, turn off the
unit and turn it on again.
Loading…
The unit is loading the specified file/contents.
Wait until the unit finishes loading.
No Content
Selected folder does not contain playable files.
Select a folder with playable files (
Not Connected
The unit is not connected to the Internet.
Check the Internet connection.
Unsupported
You are trying to play back a file which the unit does not support
Play a file supported by the unit (
P.44).
No Operation
You are trying to open the disc tray while setting the option menu.
Open the disc tray after the option setting is finished.
Access Denied
Access to the PC is denied.
Configure the sharing settings and select the unit as a device to which music contents are
shared (
P.17).
Access Error
The unit cannot access the USB device.
Turn off the unit and reconnect your USB device. If the problem persists, try another USB
device.
The unit cannot access the iPod.
Turn off the iPod and turn it on again.
The connected iPod is not supported by the unit.
Use an iPod supported by the unit (
There is a problem with the signal path from the network to the unit.
Make sure your router and modem are turned on.
Check the connection between the unit and your router (or hub) (
P.11).
Version Error
Firmware update is failed.
Update the firmware again.