Yamaha CP4 Stage, Owner'S Manual

Page: 43 / 60

CP4 STAGE/CP40 STAGE Owner’s Manual
43
Quick
Start Gui
d
e
Changing the master tuning
You can adjust the tuning of the stage piano as a whole
as described below.
1
Press the [UTILITY] button.
The Utility menu will be displayed.
2
Use the [
u
] button to select 01: General , and
then press the [ENTER] button.
The pane for setting the master tuning will be
displayed.
3
Move the cursor (
R
) to the MasterTune
parameter using the [
l
] button, and then
change its setting using the Data Dial.
The master tuning can be set in units of one cent.
NOTE
The stage piano’s default tuning is 440 Hz (for A3), and
3 to 4 cents is roughly equivalent to 1 Hz.
4
Press the [STORE] button.
All Utility settings will be stored in the stage piano’s
memory.
Restoring initial settings
As described below, the Factory Set function can be
used to restore your stage piano’s User Memory to its
initial condition. When executed, all Performances and
Utility settings stored in User Memory will be returned to
their defaults. This can prove useful when you have
accidentally overwritten some of the User Memory’s
default Performances and Utility settings.
NOTICE
When the Factory Set function is executed, all Performances
and Utility settings currently stored in User Memory will be
overwritten with their defaults. It is wise, therefore, to
regularly create backup copies of important data on a USB
flash-memory device or the like (page 39).
1
Press the [UTILITY] button.
The Utility menu will be displayed.
2
Use the [ d ] button to select 07: Job , and then
press the [ENTER] button.
The Utility Job menu will be displayed.
3
Use the [ u ] button to select 01: FactorySet ,
and then press the [ENTER] button.
The Factory Set screen will be displayed.
4
Set the PowerOn Auto parameter to “off”, and
then press the [ENTER] button.
The following confirmation message will be displayed
before executing the Factory Set function.
Press the [-1/NO] button if you do not wish to
proceed. In addition, you can also return to the
Performance screen by pressing the [EXIT] button
several times.
NOTICE
If you set the PowerOn Auto parameter to “on” before
executing the Factory Set function, the function will then
execute automatically whenever you subsequently turn
on your stage piano. As this can result in the loss of
important settings and data, we recommend that the
parameter normally be set to “off”. When you return the
PowerOn Auto parameter from “on” to “off”, you must
execute the Factory Set function in this condition to
store the new setting.
5
Press the [+1/YES] button.
The Factory Set function will be executed.
NOTICE
You should never turn off the stage piano while the
Factory Set function is executing — that is, while the
message is displayed on-screen. If this precaution is not
observed, the content of User Memory may be lost and
system data may become corrupted, preventing the
instrument from operating normally the next time it is
turned on.
6
Press the [EXIT] button the required number
of times to exit the Utility area.
UTILITY Ma
General R + 0 .
sterTune Trnsps E
0/440 . 0Hz + 0 D
UTILITY JOB
D 01:FactorySet
Job
FactorySet
PowerOn Auto
R off
Are you
[NO]
sure?
/[YES]