CP4 STAGE/CP40 STAGE Owner’s Manual
15
Setting Up
Setting Up
Power Supply
CP4 STAGE
1
Ensure that the [
P
] (Power) switch on the
rear panel is set to the Off (
N
) position.
2
Insert the appliance end of the bundled
power cord (see below) into the [AC IN] jack,
also on the rear panel.
3
Plug the other end of the power cord into a
domestic-use, AC wall outlet.
NOTE
Carry out this procedure in reverse order when
disconnecting the power cord.
WARNING
Use only the AC power cord supplied with your stage piano.
The use of an inappropriate replacement can lead to
overheating or electric shock.
WARNING
The power cord supplied with your stage piano must not be
used with other electrical equipment. Failure to observe this
precaution can result in the equipment being damaged or
lead to the outbreak of fire.
WARNING
Make sure your CP4 STAGE meets the voltage requirement
for the country or region in which it is being used. The power
cord includes a grounding pin to prevent electrical shock
and damage to the equipment. When connecting to an outlet,
connect the adaptor’s ground lead to the ground screw. If
you are unsure how to make this connection, contact your
Yamaha dealer or service center.
CAUTION
The stage piano remains charged and draws a small amount
of power even when the [
P
] (Power) switch is set to the Off
position. If it will not be used for an extended period of time,
therefore, be sure to unplug the power cord from the wall
outlet.
CP40 STAGE
1
Ensure that the [
P
] (Standby/On) switch on
the rear panel is set to the Standby (
N
)
position.
2
Connect the DC power cord from the bundled
power adaptor (see below) to the DC IN jack
on the rear panel.
3
Plug the adaptor’s AC power cord into a
domestic-use, AC wall outlet.
NOTE
Carry out this procedure in reverse order when
disconnecting the power adaptor.
WARNING
Be sure to use only the power adaptor supplied with your
stage piano. Use of a different adaptor is inherently
dangerous and may result in equipment damage,
overheating, or the outbreak of fire.
WARNING
Make sure your CP40 STAGE meets the voltage requirement
for the country or region in which it is being used.
CAUTION
The stage piano remains charged and draws a small amount
of power even when the [
P
] (Standby/On) switch is set to the
Standby position. If it will not be used for an extended period
of time, therefore, be sure to unplug the power adaptor from
the wall outlet.
[
P
] switch
[AC IN] jack
DC IN jack
Summary of Contents for CP4 Stage
Page 1: ...EN Owner s Manual STAGE PIANO ...
Page 59: ......
