Recording Your Performance
CP300 Owner’s Manual
44
Basic Oper
ation
This section explains how to record a specific section or part of a Song again.
1
Use the B [– (NO)][+ (YES)] buttons while the playback display is displayed to move
through the measures, or play back the recording and press the [PLAY/PAUSE]
button to locate a point slightly prior to the beginning of the part you wish to re-
record.
If the playback display does not appear, press one of the SONG SELECT [
N
][
O
] buttons once.
2
Select a Voice or Voices for recording, if necessary.
Repeat Step 2 on page 42 if you wish to change the previous settings.
3
Press and hold down the [REC] button, and press one of the C [–][+] buttons
repeatedly to specify how the recording should start. Similarly, use the D [–][+]
buttons to specify how the recording should end.
While you are holding down the [REC] button, the following recording method select display appears.
Starting methods:
Norm:
All existing data in the Song will be erased after re-recording starts.
Key On:
Data that exists prior to the point where you start playing a note will not be erased (when re-
recording part of the Song).
Ending methods:
Replace:
Existing data following the point at which you stopped recording will be erased.
Punch Out:
Existing data following the point at which you stopped recording will remain.
4
Select a recording track, then start recording.
After this, follow the procedure beginning with Step 3 on page 42.
Re-recording Parts of a Song
PresetSong Bar 012
P-000:NewSong
NO
YES
A
B
D
C
Indicates the current measure.
(The words “bar” and “measure” are used interchangeably.)
RecMode ExtraTrackCh=3
Start:Norm End:Replace
NO
YES
A
B
D
C
