134
Utility
Micro Tuning (MICRO TUNING) Display —
PAGE
14
The Micro Tuning Feature makes it possible to individually tune each
key of the keyboard. The created tuning can be saved to a disk and
loaded whenever necessary. The set tuning can be turned on or off at
anytime by using the left-most LCD button in this display.
Z
Select the desired key.
................................................................................
Press any desired key to be tuned.
➔
The note name and the current tuning value of the pressed key
will appear in the display.
X
Set the tuning.
......................................................................................................
Press the
TUNE
▼
or
▲
buttons or use the data dial or
[–/+]
to tune
the pitch of the selected key. If you set the parameter at the left-most
LCD button to ON, you can play the key being tuned in order to check
the sound during this operation. The normal tuning of
±
0 cents for the
selected key can be instantly recalled by simultaneously pressing both
the
TUNE
▼
or
▲
buttons.
• Range: –100 cents (– 1 semitone) —
+100 cents (+ 1 semitone)
• Basic Value: 0 (for all keys)
• Backup of last settings: OFF
C
Repeat steps 1 and 2.
...................................................................................
Repeat steps 1 and 2 until all the required keys have been tuned.
......................................................................................................................................................
The completed tuning can be named as a tuning file and saved to
disk. It can also be loaded whenever necessary or deleted if not needed.
Make sure that a proper disk (either containing the micro tuning data
or set up for saving) is inserted in the disk drive before executing these
file operations.
Z
Select the desired file operation.
....................................................
Use the LCD button located second from right to select the desired
file operation:
LOAD
,
SAVE
,
DELETE
or
NAME
.
X
Press the
START
button.
............................................................................
After the
START
button is pressed, the display corresponding to the
selected file operation appears.
The subsequent steps are the same as those explained on pages 125
and 126. Refer to the pages below, depending on the selected file opera-
tion.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
