Yamaha CEmarking RCX221, User Manual

Page: 302 / 468

4-234
Chapter
4
OPERA
TION
12. "SYSTEM" mode
Valid keys and submenu descriptions in "SYSTEM>INIT>MEMORY" mode are shown
below.
Valid keys Menu Function
F1 PROGRAM Deletes the program data.
F2 POINT Deletes the point data.
F3 SHIFT Initializes the shift coordinate data.
F4 HAND Initializes the hand definition data.
F5 ALL
Deletes/initializes all data (program, point, shift
coordinates, hand definition, pallet definition, point
comment).
F6 PALLET Deletes the pallet definition data.
F7 COMMENT Deletes the point comment data.
12.4.3 Initializing the communication parameters
To initialize the communication parameters, proceed as follows.
[Procedure]
1) Press (CMU) in "SYSTEM>INIT" mode.
A confirmation message appears on the guideline
■
Initializing the communication parameters
SYSTEM >INIT>CMU V9.00
MODE ,DATA,RATE,STOP,PARI,TERM,XON,RTS
ONLINE, 8,9600, 1 ,ODD ,CRLF,YES,NO
Initialize OK? YES NO
2) Press (YES) to initialize the parameter.
If not initializing, press (NO).
Values to be set are as follows.
1. Communication mode = ONLINE
2. Data bit = 8 bits
3. Baud rate = 9600bps
4. Stop bit = 1 bit
5. Parity = ODD
6. Termination code =CRLF
7. Flow control