Yamaha CEmarking RCX221, User Manual

Page: 263 / 468

4-195
Chapter
4
OPERA
TION
12. "SYSTEM" mode
12.1.4.3 Setting the network parameters
When using Ethernet, you set five parameters including the parameter to enable or disable
the Ethernet board.
c
CAUTION
When making the Ethernet settings to use TELNET, you will need to set any
other parameters than those shown below. For more details, see the Ethernet
manual.
Parameter Meaning
1 Board condition
Enables or disables the Ethernet board. When set to
"VALID" the Ethernet can be used. When set to
"INVALID" Ethernet cannot be used.
2 IP address Sets the IP address.
3 Subnet mask Sets the subnet mask.
4 Gateway Sets the gateway.
5
Communication
mode Sets the communication mode (online/offline).
Online commands can be run only in the online mode.
n
NOTE
• The communication mode parameter is applicable to a controller of Ver.
9.27 onwards.
• The communication mode parameter can also be changed by the
ONLINE or OFFLINE statement of the robot language.
[Procedure]
■
Network setting (1)
SYSTEM >PARAM>OP.BRD V9.00
1.E_Net
VALID
2.
3.
4.
SELECT
1) In "SYSTEM>PARAM>OP. BRD" mode, select "E_Net" with the cursor keys and press
(SELECT).