Yamaha CEmarking RCX221, User Manual

Page: 255 / 468

4-187
Chapter
4
OPERA
TION
12. "SYSTEM" mode
12.1.4 Parameters for option boards
This section explains how to set parameters for option boards from the RPB.
Option boards are roughly divided into three types: option DIO boards, serial I/O boards
and network board.
For option DIO boards, there are 2 parameters to be set, including the parameter to enable
or disable the DC 24V power input monitor. For serial I/O boards (CC-Link/DeviceNet/
PROFIBUS), there are 3 parameters including the parameter to enable or disable the
boards. When using a network board (Ethernet), there are 4 parameters including the
parameter to enable or disable the board.
n
NOTE
• For detailed information on serial I/O units such as CC-Link, Ethernet, and
YC-Link, refer to their respective manuals.
• On controllers with a DeviceNet board installed and from Ver. 9.08
onwards, there are 4 parameters to be set. Earlier version controllers
require 3 parameters to be set.
• No parameter setting is required for the YC-Link.
[Procedure]
1) Press (OP. BRD) in "SYSTEM>PARAM" mode to enter the option board
parameter setting mode.
The option boards installed in the controller are displayed in order on the RPB screen.
■
Option board parameter screen
SYSTEM >PARAM>OP.BRD V9.00
1.D_Net(M4/500k)
VALID
2.DIO_P(n)
VALID
3. ---
4. ---
SELECT