Yamaha C-5000, Owner'S Manual, Page: 29 / 324

29
English
Selecting the input from the
EXT.IN jacks
Press the EXT. DIRECT switch. The EXT. DIRECT
indicator will light up. The INPUT selector setting will
be disabled, and the audio source input from the EXT.
IN jacks will be output at a pair of the output jacks. The
source signal input at the balanced input jacks will be
output at the balanced BAL output jacks. The source
signal input at the LINE input jacks will be output at the
LINE 1 and LINE 2 output jacks.
If you press the EXT. DIRECT switch again or rotate
the INPUT selector, the signal specified by the INPUT
selector will become the input source. The EXT. DIRECT
indicator will turn off.
Note
If EXT . DIRECT is selected, no signal will be output at the
LINE 2 OUT (recording) jacks nor at the PHONES jack .
Adjusting the
turntable input
setting
PHONO selector
Set the PHONO selector according to the turntable
cartridge.
Options for turntable cartridge
MM-type cartridge
MC-type cartridge (about 300Ω)
MC-type cartridge (about 100Ω)
MC-type cartridge (about 30Ω)
MC-type cartridge (about 10Ω)
CAUTION
If an MM-type cartridge is used on the turntable, be sure to
set the PHONO selector to MM .
Note
Impedance labels on the PHONO selector indicate
approximate values . Listen to and check the sound with
different impedance settings to select the most appropriate
option .
NOTICE
Before you replace the cartridge, be sure to turn off the
power to this unit .