Operation an
d
important ri
d
in
g
points
6-2
6
2. Shift the transmission into the
neutral position. The neutral indi-
cator light should come on. If not,
ask a Yamaha dealer to check the
electrical circuit.
3. Start the engine by pushing the
start switch.
If the engine fails to start, release
the start switch, wait a few sec-
onds, and then try again. Each
starting attempt should be as
short as possible to preserve the
battery. Do not crank the engine
more than 10 seconds on any one
attempt.
NOTICE
ECA11043
For maximum en
g
ine life, never ac-
celerate har
d
when the en
g
ine is
col
d
!
EAU16674
Shiftin
g
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
TIP
To shift the transmission into the neu-
tral position (
), press the shift pedal
down repeatedly until it reaches the
end of its travel, and then slightly raise
it.
NOTICE
ECA10261
Even with the transmission in
the neutral position,
d
o not
coast for lon
g
perio
d
s of time
with the en
g
ine off, an
d
d
o not
tow the motorcycle for lon
g
d
is-
tances. The transmission is
properly lu
b
ricate
d
only when
the en
g
ine is runnin
g
. Ina
d
e-
quate lu
b
rication may
d
ama
g
e
the transmission.
Always use the clutch while
chan
g
in
g
g
ears to avoi
d
d
am-
a
g
in
g
the en
g
ine, transmission,
an
d
d
rive train, which are not
d
esi
g
ne
d
to withstan
d
the
shock of force
d
shiftin
g
.
EAU16682
To start out an
d
accelerate
1. Pull the clutch lever to disengage
the clutch.
2. Shift the transmission into first
gear. The neutral indicator light
should go out.
3. Open the throttle gradually, and at
the same time, release the clutch
lever slowly.
1. Gear positions
2. Shift pedal
2
1
1
N
2
3
4
5
UBP612E0.book Page 2 Tuesday, July 3, 2018 4:41 PM
