Yamaha BIG BEAR 250 YFM250Z, Owner'S Manual

Page: 124 / 140

8-45
8
EBU25611
Replacing the tail/brake light bulb
If the tail/brake light bulb burns out, replace it as
follows.
1. Remove the bulb holder (together with the
bulb) by turning it counterclockwise.
2. Remove the burnt-out bulb by pushing it in
and turning it counterclockwise.
3. Insert a new bulb into the bulb holder, push it
in, and then turn it clockwise until it stops.
4. Install the bulb holder (together with the bulb)
by turning it clockwise.
EBU25651
Removing a wheel
1. Place the ATV on a level surface.
2. Loosen the wheel nuts.
1. Tail/brake light bulb holder
1. Tail/brake light bulb holder
2. Tail/brake light bulb
U1P065E0.book Page 45 Monday, August 31, 2009 1:10 PM