26
BD-940
BD-940
8. When writing of the firmware is completed, the screen appears as shown below. (Fig. 6)
Click [OK]. (Fig. 6)
9. Click [Exit] to end FlashSta.exe. (Fig. 6)
Fig. 6
10. Disconnect the power cable of this unit from the AC outlet.
11. Remove the RS232C conversion adaptor and flexible flat cable from the writing port (CB801 of MAIN P.C.B.) of this
unit.
12. Start up the self-diagnostic function.
Using the “6. Firmware version” / “7. Checksum” menu, have the firmware version and checksum displayed, and
then check that they are the same as written ones. (See “SELF- DIAGNOSTIC FUNCTION”)
*
When the firmware version and checksum are different from written ones, perform the “Operation procedure”
from the beginning.
13. Press the “ ” (On/Standby) key of this unit to turn off the power.
14. Disconnect the power cable of this unit from the AC outlet.
Summary of Contents for BD-940
