En
20
2.1-channel system
Even when no surround speakers are connected, the unit creates the virtual surround
speakers using the front speakers to allow you to enjoy multichannel surround sound
(Virtual CINEMA DSP).
• Add the center speaker to configure a 3.1-channel system.
■
Setting the speaker impedance
Under its default settings, the unit is configured for 8-ohm speakers. When using a
6-ohm speaker for any channel, set the speaker impedance to “6
MIN”. In this case,
you can also use 4-ohm speakers as the front speakers.
1
Before connecting speakers, connect the power cable to an AC wall
outlet.
2
While holding down STRAIGHT on the front panel, press
MAIN ZONE
z
.
3
Check that “SP IMP.” is displayed on the front display.
4
Press STRAIGHT to select “6
MIN”.
5
Press MAIN ZONE
z
to set the unit to standby mode and remove the
power cable from the AC wall outlet.
You are now ready to connect the speakers.
1
2
9
MAIN ZONE
z
STRAIGHT
SPIMP.8MIN
1 2 3 4 5 6 7 8 9 10 11
