Yamaha Aventage RX-A1080, Quick Start Manual

Page: 9 / 136

En
9
2
Connecting speakers/subwoofer
Positioning speakers
Use the diagram as a reference for positioning speakers.
1
/
2
Front speaker (L/R)
3
Center speaker
4
/
5
Surround speaker (L/R)
E
/
R
Front presence speaker (L/R)
1)
9
Subwoofer
2)
1)
For 5.1.2-channel system
2)
Up to two subwoofers can be connected.
When connecting 6-ohm speakers
Set the unit’s speaker impedance to “6 Ω MIN”. For details, see “Setting the
speaker impedance” under “Connecting speakers” in the Owner’s Manual.
Precautions for connecting speaker cables
• Be sure that the unit and subwoofer are turned off.
• Prepare speaker cables in a place away from the unit, to avoid accidentally
dropping wire strands into the unit's interior which could result in a short
circuit or malfunction of the unit.
• Improper connection of speaker cables could cause a short circuit resulting
in damage to, or malfunctioning of, the unit or speakers.
– Carefully remove approximately 10 mm
(3/8") of insulation from the speaker-
connection ends of the cables, and twist
the bare wires of each speaker cable
together firmly.
– Do not allow the bare wires of separate speaker
cables to come into contact with one another.
– Do not allow speaker cable bare wires to come into
contact with metal parts on the unit (rear panel and
screws).
If “Check SP Wires” is shown on the front display when the unit is turned on,
turn off the unit and be sure that speaker cables have not caused a short
circuit.
4
1 2
9
E R
5
3
1)
2)
1)
10° to 30° 10° to 30°
10 mm
(3/8")