Yamaha AVENTAGE RX-A1060, Owner'S Manual, Page: 101 / 190

En
101
⬛
Rename/Icon Select
Changes the input source name and icon displayed on the front display or TV screen.
Input sources
AV 1-7, V-AUX, AUDIO 1-3, PHONO, USB
⬛
Setup procedure
1
Use the Cursor keys (
e
/
r
) to select “Auto” or “Manual” and press the Cursor key (
w
).
If you select “Auto”, the unit creates a name automatically according to the connected device.
Proceed to Step 3.
X
This step is available only when “AV1-7”, “V-AUX” or “AUDIO1-3” is selected.
2
Use the Cursor keys (
e
/
r
) to select a template and press the Cursor key (
w
).
3
Use the Cursor keys (
e
/
r
) to select an icon and press the Cursor key (
w
).
4
Press ENTER to enter the name edit screen.
5
Use the Cursor keys and ENTER to rename and select “ENTER” to confirm the entry.
X
To clear the entry, select “CLEAR”.
6
Use the Cursor keys to select “OK” and press ENTER.
X
To restore the default setting, select “RESET”.
7
To exit from the menu, press ON SCREEN.
⬛
Decoder Mode
Sets the format of digital audio playback to “DTS”.
For example, if the unit does not detect DTS audio and outputs noise, set “Decoder Mode” to
“DTS”.
Input sources
AV 1-7, V-AUX, AUDIO 1-3 (available only when any audio digital input jack is assigned)
Settings
⬛
Volume Interlock
Enables/disables volume controls from iTunes/iPod via AirPlay.
Input sources
AirPlay
Settings
Auto Automatically selects an audio format to match the input audio signal.
DTS Selects DTS only. (Other audio signals are not reproduced.)
Off Disables volume controls from iTunes/iPod.
Limited
Enables volume controls from iTunes/iPod within the limited range (-80 dB to -20
dB and mute).
Full
Enables volume controls from iTunes/iPod in the full range (-80 dB to +16.5 dB
and mute).