Error messages from YPAO
If any error message is displayed, resolve the problem by following on-screen instructions and perform YPAO
again.
[Search tag]#Q03 YPAO Error
Error message
Remedy
E-1:No Front SP
Exit YPAO, turn off the unit, and then check the speaker connections.
E-2:No Sur. SP
E-3:No F.PRNS SP
E-4:No Sur. Back SP
E-5:Noisy
Keep the room quiet and retry YPAO. If you select “PROCEED”, YPAO takes the
measurement again and ignores any noise detected.
E-6:Check Sur.
Surround speakers need to be connected in order to use surround back speakers. Exit
YPAO, turn off the unit, and then reconnect the speakers.
E-7:No MIC
Connect the YPAO microphone to the YPAO jack firmly and retry YPAO.
E-8:No Signal
Connect the YPAO microphone to the YPAO jack firmly and retry YPAO. If this error
occurs repeatedly, contact the nearest authorized Yamaha dealer or service center.
E-9:User Cancel
Retry or exit YPAO as necessary.
E-10:Internal Err.
Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or service center.
NOTE
(
To exit the YPAO measurement for resolving the problem, press ENTER, and select “EXIT”.
(
For the E-5 and E-9 messages only, you can proceed with the YPAO measurement. Press ENTER, and select “PROCEED”.
(
To retry the YPAO measurement from beginning, press ENTER, and select “RETRY”.
102
PREPARATIONS > Configuring the speaker settings
