Instrument operation
44
No-wake mode
The no-wake mode is useful for operating the
boat at a steady speed with a minimal wake.
This is especially convenient when traveling
in harbors, channels, or other areas posted
with low speed limits as “no wake zones”.
The no-wake mode can be used only when
the engine is operating at idle speed.
To activate the no-wake mode:
(1) Put the remote control lever in the for-
ward position so that the engine is oper-
ating at idle speed.
(2) Push the plus side of the no-wake
mode/cruise assist switch. Once “No
Wake Mode” flashes in the LCD and the
buzzer sounds, the no-wake mode is ac-
tivated.
1
Plus side “
”
TIP:
The no-wake mode can be set to 3 engine
speeds. To adjust the engine speed while the
no-wake mode is activated, push the plus side
or minus side of the no-wake mode/cruise as-
sist switch.
To deactivate the no-wake mode:
Perform one of the following operations.
●
Push the minus side of the no-wake
mode/cruise assist switch until the LCD re-
turns to the normal display.
1
Minus side “
”
●
Push the remote control lever forward to
open the throttle.
Cruise assist
The cruise assist feature is for steady engine
speed operation when the boat is traveling
above no-wake speeds. The cruise assist is
available for use whenever the engine is run-
ning above 3000 rpm and below 7000 rpm.
To activate the cruise assist:
(1) Push the remote control lever forward to
open the throttle until the desired engine
speed is reached.
(2) Push the plus side or minus side of the
no-wake mode/cruise assist switch.
1
1600 RPM
No Wake Mode
1
SportsBoat.book Page 44 Monday, October 31, 2011 4:12 PM
