Control functions
18
TIP
If the steering load is too heavy (i.e., exces-
sive steering use when the snowmobile is
traveling at a slow speed), the power assist is
reduced to protect the EPS motor from over-
heating.
ESU13365
Self-diagnosis device
This model is equipped with a self-diagnosis
device for various electrical circuits.
If a problem is detected in any of those cir-
cuits, the warning light and the engine trouble
warning indicator flash, and an error code dis-
plays in the meter display. Note the error
code, and then have a Yamaha dealer inspect
the snowmobile as soon as possible.
NOTICE:
Do not continue to operate the
engine longer than necessary if there is an
error code to avoid possible engine dam-
age.
[ECS00820]
ESU10531
Engine stop switch “ ”
The engine stop switch is used to stop the en-
gine in an emergency. Simply push the stop
switch to stop the engine. To start the engine,
pull the stop switch and proceed with starting
the engine. (See page 37 for engine starting
procedures.)
During the first few rides, practice using the
stop switch so that you can react quickly in an
emergency.
ESU10661
Headlight beam switch
“LIGHTS”
Push the headlight beam switch to change the
headlight to high beam “HI” or to low beam
“LO”.
1. Electric power steering warning indicator
“EPS”
1. Warning light “
”
2. Engine trouble warning indicator “
”
3. Error code display
1. Engine stop switch “
”
3
2
1
U8HG10E0.book Page 18 Tuesday, May 18, 2010 5:39 PM
