Yamaha A3000, Owner'S Manual

Page: 114 / 376

112
Chapter 4 PLAY Mode
SAMPLE Function
SAMPLE Function
This section describes the PLAY-mode SAMPLE function. You can use this function to
assign samples to programs, to save samples to disk, and to build sample banks.
SAMPLE -
SmpSel
(Select Sample)
Selects sample (or sample bank) for playback or editing, or saves data to disk.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select
SmpSel
.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action
✔ ✔ ✔ ✔
-
Push action
✔ ✔ ✔
-
✔
Use this page to assign samples to the current program, to select samples for editing, or
to save the selected sample to disk.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the SAMPLE function. Available
pages are:
SmpSel
(this page),
SmpBank
,
ToBank
, and
SmpSort
.
• Push the knob to move to the Program/Sample Selection screen. (
☞
95)
Knobs 2, 3
Sample
= sample name Edit the Name
• Turn either knob to select a sample (or sample bank) for program assignment or disk
save. Once you have selected the sample, you can use Knob 4 to assign it to (or de-
assign it from) the current program, and you can use Knob 5 to save it to disk.
If you select a sample bank, a
[B]
mark appears in front of the name. If you select a
stereo sample, an
[S]
mark appears in front of the name.
If you select a new or edited sample that has not yet been saved to disk in its current
form, an
[E]
(“edited”) mark appears to the right of the name.
• If you wish to set or change the sample name, push either knob to proceed to the
name-editing screen. For information about how to edit name strings, see “Entering
Names” (
☞
88).