9
En
English
INTR
ODUCTION
AD
DITIONAL
INFORMA
T
ION
APPENDIX
PRE
P
ARA
T
ION
BA
S
IC
OPERA
T
ION
AD
V
ANCED
OPERA
T
ION
PREPARATION
1
Take off the battery compartment cover.
2
Insert the two supplied batteries (AAA, R03,
UM-4) according to the polarity markings (+
and –) on the inside of the battery
compartment.
3
Snap the battery compartment cover back
into place.
Notes
•
Change all batteries if you notice the following conditions:
–
the operation range of the remote control narrows
–
the transmit indicator does not flash or is dim
•
Do not use old batteries together with new ones.
This may shorten the life of the new batteries or cause old batteries
to leak.
•
Do not use different types of batteries (such as alkaline and
manganese batteries) together. Specification of batteries may be
different even though they look the same.
•
If you find leaking batteries, discard the batteries immediately,
taking care not to touch the leaked material. If the leaked material
comes into contact with your skin or gets into your eyes or mouth,
rinse it away immediately and consult a doctor. Clean the battery
compartment thoroughly before installing new batteries.
•
Dispose of the old batteries correctly in accordance with your local
regulations.
•
If the remote control is without batteries for more than 2 minutes,
or if exhausted batteries remain in the remote control, the contents
of the memory may be cleared. In such a case, install new batteries
and set the remote control code.
The remote control transmits a directional infrared ray. Be
sure to aim the remote control directly at the remote
control sensor on this unit during operation.
Notes
•
Do not spill water or other liquids on the remote control.
•
Do not drop the remote control.
•
Do not leave or store the remote control in the following conditions:
–
places of high humidity, such as near a bath
–
places of high temperatures, such as near a heater or stove
–
places of extremely low temperatures
–
dusty places
y
•
You can operate external components with this remote control by setting
the remote control code. See page 59 for details.
Preparing remote control
Installing batteries in the remote
control
1
3
2
Using the remote control
30
30
Remote control sensor window
within 6 m (20 ft)
