153
E
6. Adjust:
• Throttle cable joint position
Adjustment steps:
• Turn the throttle grip to the fully closed
position.
• Align the mark
a
on the throttle lever
1
with the mark
b
on the shift bracket.
• Pull the inner cable of the throttle cable
towards the engine until the free play is
removed.
• Adjust the position of the cable joint
2
until its hole aligns with the set pin.
• Install the clip
3
, and then tighten the
locknut
4
.
WARNING
The cable joint must be screwed in a
minimum of 8.0 mm (0.31 in).
7. Check:
• Fully closed position
Incorrect
→
Adjust.
8. Check:
• Throttle operation
Unsmooth operation
→
Adjust.
Checking steps:
• Turn the throttle grip to the fully closed
position.
• Check that the cam roller on the throttle
control lever is aligned with the throttle
cam as shown.
Checking steps:
• Turn the shift lever to the neutral position.
• Fully open and close the throttle several
times.
• Check that the throttle valve fully opens
and closes.
TillerHandle.book Page 153 Friday, April 12, 2013 3:19 PM
