Yamaha 2016 Grizzly yf700gg, Service Manual

Page: 173 / 474

HANDLEBAR
4-50
EBS30393
REMOVING THE HANDLEBAR
1. Place the vehicle on a level surface.
2. Remove:
• Handlebar grips “1”
TIP
Blow compressed air between the handlebar
end and the handlebar grip, and gradually push
the grip off the handlebar.
EBS30394
CHECKING THE HANDLEBAR
1. Check:
• Handlebar
Bends/cracks/damage
→
Replace.
WARNING
EWB03680
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
EBS30395
INSTALLING THE HANDLEBAR
1. Place the vehicle on a level surface.
2. Install:
• Handlebar
• Handlebar holders
• Handle mounted light assembly
TIP
• Install the handlebar within 15° from the hori-
zontal line shown in the illustration.
• The handlebar holders should be installed with
the punch mark “a” forward “A”.
• Align the punch mark “b” on the handlebar with
the lower surface of the right handlebar holder.
• First tighten the bolts “1” on the front side of the
handlebar holders, and then tighten the bolts
“2” on the rear side.
3. Install:
• Handlebar grips “1”
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Wipe off grease or oil on the handlebar sur-
face “a” with a lacquer thinner.
b. Apply a thin coat of rubber adhesive onto the
left and right ends of the handlebar.
c. Install the handlebar grips to the handlebar so
that arrow mark “L” faces up on the left han-
dlebar grip and the arrow mark “R” faces up
on the right handlebar.
T
R
.
.
Handlebar holder bolt
20 Nm (2.0 m·kgf, 14 ft·lbf)
b