INSTRUMENT AND CONTROL FUNCTIONS
4-7
4
EAU13651
Kickstarter
To start the engine, fold out the kick-
starter lever, move it down lightly with
your foot until the gears engage, and
then push it down smoothly but force-
fully. This model is equipped with a pri-
mary kickstarter, allowing the engine to
be started in any gear if the clutch is
disengaged. However, shifting the
transmission into the neutral position
before starting is recommended.
EAU46283
Seat
To remove the seat
Remove the bolts, and then slide the
seat to the rear and pull upward.
To install the seat
1. Fit the slot in the seat onto the pro-
jection on the fuel tank, and insert
the projection on the seat into the
seat holder as shown.
2. Place the seat in the original posi-
tion, and then tighten the bolts.
TIP
Make sure that the seat is properly se-
cured before riding.
1. Kickstarter lever
1. Bolt
1
1. Slot
2. Projection
3. Seat holder
1
2
3
2
U1SN83E0.book Page 7 Monday, September 8, 2014 2:36 PM
