PERIODIC MAINTENANCE AND ADJUSTMENT
7-29
7
8. Place the ignitor unit panel in the
original position and install the
quick fasteners.
TIP
To install a quick fastener, push its pin
back so that it will protrude from the fas-
tener head, then insert the fastener and
push the protruding pin in until it is flush
with the fastener head.
9. Install the rider seat.
EAU23794
Replacing the headlight bulb
This model is equipped with a quartz
bulb headlight. If the headlight bulb
burns out, replace it as follows.
NOTICE
ECA10660
Do not touch the glass part of the
headlight bulb to keep it free from
oil, otherwise the transparency of
the glass, the luminosity of the bulb,
and the bulb life will be adversely af-
fected. Thoroughly clean off any dirt
and fingerprints on the headlight
bulb using a cloth moistened with al-
cohol or thinner.
1. Remove the headlight unit by re-
moving the screws.
2. Disconnect the headlight coupler,
and then remove the bulb cover.
3. Unhook the headlight bulb holder,
and then remove the burnt-out
bulb.
1. Quick fastener (after removal)
2. Quick fastener (before installation)
1. Do not touch the glass part of the bulb.
1. Screw
1. Headlight bulb holder
U3B823E0.book Page 29 Wednesday, November 12, 2008 2:08 PM
