Yamaha 2008 YZF-R6X, Service Manual

Page: 77 / 434

CABLE ROUTING
2-46
1. Clutch cable
2. Main switch lead
3. Left handlebar switch lead
4. Horn lead
5. Horn
6. Front brake hose
7. Throttle cable (return side)
8. Throttle cable (pull side)
9. Right handlebar switch lead
10.Steering cover
11.Front fork
A. Fasten the left handlebar switch lead in
front of the front fork with a plastic locking
tie. Face the end of the plastic locking tie
outward and cut off the excess end of the
tie to 1–5 mm (0.04–0.20 in).
B. Be sure to position the plastic locking tie
above where the horn leads branch off
from the other leads.
C. Set the front brake hose in front of the vehi-
cle and outward and secure it between 2–
22 degrees angle. Direct the tip of the plas-
tic locking tie to outer side of the vehicle
and cut it by leaving the tip 2–4 mm (0.08–
0.16 in).
D. 20–30 mm (0.79–1.18 in)
E. Route the right handlebar switch lead
between the front brake master cylinder,
front fork and handlebar and above the
front brake hose union bolt.
F. Route the throttle cable through the cable
guide so that the throttle cable (pull side) is
under the throttle cable (return side).
G. Install the horn lead L-shaped connectors
so that the leads are routed outward.