Yamaha 2008 YZF-R6X, Service Manual

Page: 53 / 434

TIGHTENING TORQUES
2-22
NOTE:
Front wheel axle pinch bolt
1. Insert the front wheel axle from the right side and tighten it with the flange bolt from the left side
to 91 Nm (9.1 m·kg, 66 ft·lb) without performing temporary tightening.
2. In the order pinch bolt “2”
→
pinch bolt “1”
→
pinch bolt “2”, tighten each bolt to 21 Nm (2.1 m·kg,
15 ft·lb) without performing temporary tightening.
3. Check that the right end of the front axle is flush with the front fork. If necessary, manually push
the front axle or lightly tap it with a soft hammer until its end is flush with the front fork. However,
if the surface of the front axle end is not parallel to the surface of the front fork, align a point on
the outer edge of the axle with the fork, making sure that the axle does not protrude past the
fork.
4. In the order pinch bolt “4”
→
pinch bolt “3”
→
pinch bolt “4”, tighten each bolt to 21 Nm (2.1 m·kg,
15 ft·lb) without performing temporary tightening.
Front cowling assembly bolt M6 4 13 Nm (1.3 m·kg, 9.6 ft·lb)
Seat lock assembly bolt M6 2 7 Nm (0.7 m·kg, 5.2 ft·lb)
Rider seat and frame M6 2 7 Nm (0.7 m·kg, 5.2 ft·lb)
Battery box and frame M6 2 4 Nm (0.4 m·kg, 3.0 ft·lb)
Rear upper cowling damper plate
and frame
M6 4 7 Nm (0.7 m·kg, 5.2 ft·lb)
License plate light assembly bolt M6 4 7 Nm (0.7 m·kg, 5.2 ft·lb)
Rider footrest (left and right)
assembly bolt
M8 4 28 Nm (2.8 m·kg, 21 ft·lb)
Passenger footrest (left and right)
bolt
M8 4 28 Nm (2.8 m·kg, 21 ft·lb)
Rear brake master cylinder bolt M6 2 13 Nm (1.3 m·kg, 9.6 ft·lb)
Sidestand assembly and frame
bolt
M8 3 26 Nm (2.6 m·kg, 19 ft·lb)
Coupler holder (left and right) and
frame bolt
M6 4 7 Nm (0.7 m·kg, 5.2 ft·lb)
Shift arm bolt M6 1 10 Nm (1.0 m·kg, 7.4 ft·lb)
Locknut (shift rod upper side) M6 1 7 Nm (0.7 m·kg, 5.2 ft·lb)
Locknut (shift rod lower side) M8 1 10 Nm (1.0 m·kg, 7.4 ft·lb)
Item
Threa
d size
Q’ty Tightening torque Remarks
LS
LT
LT
4
1
3
2